Removal of lipids from the virus envelope -> e.g.Denaturation -> destruction of the virus surface.A list of all tested and approved disinfectants to fight Covid-19 is available from United States Environmental Protection Agency found here: The agents listed can inactivate the corona virus, which means it loses its ability to be infectious. All disinfectants with a virucidal (antiviral) or limited virucidal spectrum of efficacy are effective against coronaviruses. All products are disinfected prior to shipping.Ĭoronaviruses are encased viruses, meaning they are encased in a lipid envelope. We are taking precautions as necessary, with staff wearing gloves, use of Personal Protective Equipment and increased cleaning methods. Place the protective cap back on your Daysy.Allow to air-dry (the sensor neck should not touch any other objects or surfaces).When necessary, a cotton swab can be moistened with disinfectant and inserted into the protective cap to clean the inside. Moisten the sensor neck and tip with a disinfectant (limited virucidal), alcohol (60-80%) or isopropanol 70%.Clean the sensor neck and tips (as per steps 1 & 2 listed above).Wash your hands thoroughly or wear disposable gloves.If the device needs to be disinfected as well, the following steps can be practiced: This cleaning is sufficient for daily personal use with Daysy. These steps will reduce the number of germs or possible viruses on the surface of the device. Replace the protective cap after drying.Regularly clean the sensor tip with water and /or some mild soap after use.We recommend the following steps for cleaning your Daysy: Since your Daysy is not waterproof, make sure that only the neck on the sensor and not the whole appliance comes into contact with water. You can also use a little alcohol or soap if you wish. Use a damp cloth to carefully clean the sensor on your Daysy. A temperature reading can only be recorded once a day. Please wait and take your temperature tomorrow morning. Please make sure you have removed the cap from Daysy sensor before placing it under your tongue, that your lips are closed around the neck of the sensor, and you do not move the sensor around while recording.ĭaysy 2.0: The "beep-beep" sound is Daysy's way of indicating that temperature reading has already been recorded for this day. If Daysy makes the “grumble-buzz” sound when you are recording your temperature, then she is indicating that your temperature value is too low, too high, or too unstable. If your cable is not connected, then please turn Daysy on, insert and remove the cable several times, then press the button again to enter the temperature reading mode. Please turn Daysy on, remove the cable and then press the button again to enter the temperature reading mode.
0 Comments
Leave a Reply. |